![]() ![]() To present a frame as a bit field, right-click on the frame and click on Message bit-map in the context menuĪfter which the window with the bit field of the selected frame appears The trigger is activated by click the RUN button on the selected frame.įrames can be presented as a bit field, which is convenient, for example, when searching for binary signals such as: In this example, channels #1 and #2 were combined physically for illustration, so the automatically sent frame via channel #2 we see accepted in channel #1. In the screenshot above, the trigger is configured as follows: In this case the transfer will start only if the frame specified in the trigger settings is accepted. You can set the trigger for each message for automatic transmission. The Shot button sends the selected frame once. In addition, right-click on the Transmit window – You can perform group operations – Run All and Stop All, as well as save and load the transferred frames into a file. You can select a channel, type ID 11 or type 29 bits, and the batch time when you press the Run button. To transfer CAN frames in the Transmit window, click the Add button and form the required frame. If CAN-Hacker is connected to one or two CAN buses and the speed of CAN is determined correctly, the physical connection to the CAN bus is correct and there is activity on the bus, then you will see the frames passed across the bus in the receiving window because in the image below.įor the convenience of analyzing data transmitted through different channels, click the Splitter button in the top menu (the arrow on the photo above) and the data of each channel will be displayed in its own window. To know the estimated approximate value, press the button “?”Īfter configuring the CAN adapter and CAN channels in the top menu, click Connect In this case it is necessary to set the Low accuracy flag and CARBUS Analyzer will set the CAN channel speed as close as possible to the entered value. If the entered baudrate doesn’t allow the integer divisor to be calculated, the value entered will be highlighted in red. If the clock divisor is an integer, then the input value will be displayed on a white background and after pressing the OK button, the CAN channel will run at the specified speed. Once the speed is entered, an attempt will be made to calculate the CAN controller clock divisor. If you want to use a Custom CANbus baudrate:Ĭustom baudrate – enter the required CAN speed. Custom baudrate – user defined CAN baudrate.Channel baudrate – standart CAN baudrates.Source – Virtual COM Port (See in the Windows Device Manager). ![]() ![]() Device mode – CAN, LIN, CAN+LIN device mode.Device type – your CAN-Hacker interface type.Working with CAN bus Selecting and connecting to the interface ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |